Tail Lamp: Service and Repair

Replacement

1. Disconnect the negative (-) battery terminal.
2. Loose the screws (3EA) holding the rear combination lamp then disconnect the 4P connector then remove the outside rear combination lamp.








3. Replace the bulbs (3EA) after disconnecting the rear combination lamp assembly.




4. Disconnect the lamp cover on tailgate. Remove the lamp assembly after loosening the connector (4pin), Cap nuts (2EA) and nuts (2EA).
5. Remove the tailgate combination lamp assembly and the replace the bulbs.




6. Installation is the reverse of removal.

NOTE:
- When installing, check if the tailgate wiring harness connector is connected securely.
- Verify that the tail, stop and back up lamps of the rear combination lamps light normally.