Repair Procedures

Removal

Hand Type
1. Release the parking brake lever thoroughly.
2. Remove the console.




3. Disconnect the parking brake cable (B) from the equalizer assembly (A).




4. Disconnect the parking brake switch connector (A).
5. Remove the parking brake lever assembly by loosening the mounting bolts.




6. Remove the rear wheel & tire.
7. Remove the rear brake caliper and disc.
8. Disconnect the brake cable (A) from the parking brake assembly.




9. Loosen all of the cable guide bracket bolts.
10. Remove the both of brake shoes holder (A) and pin (B).




11. Remove the upper spring (A) and strut (B).




12. Remove the lower spring (A), adjuster assembly (B), and brake shoes.





Foot Type
1. Release the parking brake pedal thoroughly.
2. Remove the lower crash pad.




3. Remove the parking brake cable fixing clips (A), then disconnect the cable from the parking brake pedal.




4. Disconnect the parking brake switch connector (A).
5. Remove the parking brake pedal assembly by loosening the mounting bolts.




6. Remove the rear wheel & tire.
7. Remove the rear brake caliper and disc.
8. Disconnect the brake cable (A) from the parking brake assembly.




9. Loosen all of the cable guide bracket bolts.
10. Remove the both of brake shoes holder (A) and pin (B).




11. Remove the upper spring (A) and strut (B).




12. Remove the lower spring (A), adjuster assembly (B), and brake shoes.






Installation

1. Installation is the reverse of removal.
2. After installation, adjust the parking brake.

Adjustment

Parking Brake Shoe Clearance Adjustment
1. Remove the rear wheel & tire.
2. Remove the plug from the rear brake disc.
3. Rotate adjuster assembly (A) downward until it can not be rotate by using a screw driver.








4. Rotate the adjust assembly by 5 notches in the opposite direction.
5. Install the plug to rear brake disc.
6. Install the rear wheel & tire.

Parking Brake Cable Adjustment

CAUTION:
Parking brake cable adjustment must be carried out after adjusting rear shoe.

Hand Type
1. Operate the parking brake lever through a full stoke over 3 times for setting the cables.
2. The travel must be between 6 - 7 notches when applying a force of approx. 20kgf (196N, 44.1lb) at 40mm (1.57in) from the end of lever assembly by adjusting nut (A) of equalizer.




3. The parking brake indicator lamp must be OFF when lever assembly is released, and ON when operating by 1 notch.

Foot Type
4. Operate the parking brake pedal through a full stroke over 3 times for setting the cables.
5. Adjust the adjusting nut (A) for parking brake pedal stroke 8 - 9 notches when operating effort is approx. 30kgf (294N, 66lb).