Repair Procedures

Replacement

Seat Assembly Replacement
1. Remove the seat assembly mounting cover (A).
2. After loosening the seat assembly mounting bolts and nuts, remove the seat assembly (C).




3. Disconnect the connector(A).

[Driver's]





[Passenger's]




4. Installation is the reverse of removal.

NOTE:
- Be sure to perform PODS re-zero with Hi-scan (pro) after replacing parts (Passenger's)

CAUTION:
SEAT MOUNTING BOLT INSTALLATION PROCEDURE (Manual seats only)
- Set the into the most rearward position.
Check then each slide is locked, and then tighten the front mounting bolt temporarily.
- Set the seat into most forward position.
Check that each slide is locked, and then tighten the rear mounting bolt completely.
- Set the seat into the most rearward position.
Check the front mounting bolt completely.
- Check that the seat operates to and fro smoothly and the locking portion locks properly.

Recliner Cover Replacement
1. Remove the front cover (A).




2. Remove the recliner cover (A) and sliding cover (B).
3. Loosen the recliner mounting screw and clip, then remove the recliner cover (C).




4. Installation is the reverse of removal.

NOTE:
- Be sure to perform PODS re-zero with Hi-scan (pro) after replacing parts (Passenger's)

Seat Back Cover Replacement
1. Remove front seat assembly.
2. Remove the recliner cover.
3. After disconnecting the scuff band (A), remove the seat back panel (B).




4. Remove the headrest and headrest guide.
5. Disconnect the protector (A) from the back frame.




6. Disconnect the connector (A).




7. Remove the seat back(A).




8. Remove the seat back cover (A).




9. Installation is the reverse of removal.

NOTE:
- Be sure to perform PODS re-zero with Hi-scan (pro) after replacing parts (Passenger's)

Seat Cushion Cover Replacement
1. Remove front seat assembly.
2. Remove the recliner cover.
3. Disconnect the protector (A).




4. Disconnect the connector (A).





NOTE:
- The passenger front seat cushion is not serviceable(PODS).

5. Remove the seat cushion cover (A).




6. Disconnect the adhesives (A) on the front of seat cushion, remove the cushion cover (B).




7. Installation is the reverse of removal.

NOTE:
- Be sure to perform PODS RE-ZERO with Hi-scan (pro) after replacing parts (Passenger's)

Seat Frame Replacement
1. Remove the following items.
A. Recliner cover.
B. Seat back panel.
C. Headrest guide.
D. Seat back cover.
E. Seat cushion cover.
2. Remove the clip.
3. Remove the shift (A).

NOTE:
- Remove the side air bag for replacing side air bag installation seat.
- Be fore service, be fully aware of precautions and service procedure relevant to air bag.




4. After loosening the mounting bolts, then disconnect the seat back frame (A) and seat cushion frame (B).




5. Installation is the reverse of removal.

NOTE:
- Be sure to perform PODS re-zero with Hi-scan (pro) after replacing parts (Passenger's)

Seat Back Heater Replacement
1. Remove the seat back cover.
2. Cut the heater (A) attached to the sponge, as shown in the picture.





NOTE:
- Be sure to perform PODS re-zero with Hi-scan (pro) after replacing parts (Passenger's)

Seat Cushion Heater Replacement
1. Remove the seat back cover.
2. Cut the heater (A) attached to the sponge, as shown in the picture.





NOTE:
- The passenger front seat cushion is not serviceable (PODS)