Scantool Diagnostics

Power Tailgate
B2424 Clutch Short Low - Scantool Diagnostics:_:Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to Data Link Connector(DLC).
2. Ignition "ON" & engine "OFF" & PTG "ON" & Door clutch "ON"
3. Monitor the "clutch Feedback" Parameter on the Scantool.
A. Specification : 0.5V or more








Fig1) The current data in abnormal state
Fig2) DTC B2424
4. Is the measured current data within specifications?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "Inspection & Repair" procedure.