Scantool Diagnostics

Power Tailgate
B2425 Left Pinch Strip Open or Stuck High - Scantool Diagnostics:_:Monitor Scantool Data

Monitor Scantool Data

1. Connect scantool to Data Link Connector(DLC).
2. Ignition "ON" & engine "OFF" & PTG "ON"
3. Monitor the "Left Pinch Strip Voltage" Parameter on the Scantool.
A. Specification : 3.66V or less








Fig1) The current data in abnormal state
Fig2) DTC B2425
4. Is the measured current data within specifications?
YES
1) Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "Inspection & Repair" procedure.