Scantool Diagnostics

Tire Pressure Monitoring System
C1325 RR Sensor over Temp - Scantool Diagnostics:_:Monitor Scantool Data

Monitor Scantool Data

1. Connect 'TPMS exciter' or scantool to Data Link Connector(DLC).
2. Select "TPMS DIAGNOSIS" mode.
3. Select the "FULL" mode of "TPM DATA VALUES" function.
4. Monitor the parameter of "S4 TEMP." on the 'TPMS exciter' or scantool.
A. Specification : 'S4 TEMP.' is Less than 248°F(120°C)




Fig 1) Sensor current data (normal)
Fig 2) Executing "SET SENSOR STATUS"
5. Is parameter within specifications?
YES
1) Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
2) Go to "Verification of vehicle Repair" procedure.
NO
1) Go to "Component Inspection" procedure.