Scantool Diagnostics

Electronic Stability Control
C2402 Motor electrical - Scantool Diagnostics:_:Monitor Actuation Test

Monitor Actuation Test

1. Connect scantool to Data Link Connector(DLC).
2. Ignition "ON" & Engine "OFF".
3. Select the "Actuation Test" mode on the scantool.
4. Inspect operating status of Motor with Actuation Test.
A. Specification : It's normal if operating sound is heard.




Fig 1) Test Condition : Ignition "ON" & Engine "OFF".
Ex) Actuation Test on Motor
5. Does motor operate normally?
YES
1) Fault is intermittent caused by poor connection in power harness (ABS1) and/or HECU's connector or was repaired and HECU memory was not cleared.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
1) Go to "Terminal and Connector Inspection" procedure.