Exterior Moulding / Trim: Service and Repair

Replacement

Roof Rack Replacement
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.
1. Remove the roof rack cover (A).
2. Remove the roof cross bar (B).
3. Remove the roof rack (C).
4. Installation is the reverse of removal.










Front Wheel Guard Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the wheel guard (A).




2. Installation is the reverse of removal.

Rear Mud Wheel Guard Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Remove the wheel guard (A).




2. Installation is the reverse of removal.

Side Garnish And Side Sill Replacement

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Put on gloves to protect your hands.
- Take care not to scratch the body surface.

1. Prepare to remove the garnish from inside the vehicle.
A. To remove screws the front and rear door panel.
2. Remove the clips and screws and gently pry the side garnish or side sill away from the door while removing the adhesive tape.
3. Installation is the reverse of removal.
Replace any damaged clips adhesive tape.



















Tailgate Garnish Replacement
1. Remove the tailgate trim.
2. Disconnect the connector (A).
3. Remove the tailgate garnish (B).




4. Installation is the reverse of removal.

Spoiler Replacement
1. Remove the following parts.
A. Tail gate upper trim
B. Cap (A). stop lamp connector (C)
C. Rear windshield washer nozzle (B)
2. After loosening the mounting nuts, then remove the spoiler (D).




3. Installation is the reverse of removal.