Cruise Control Switch: Service and Repair

Removal

1. Disconnect the battery (-) terminal.
2. Remove the two bolts from the both sides of the wheel.




3. Remove the driver side air bag module (C) after disconnecting the air-bag connector (A) and the horn connector (B).




4. Disconnect the cruise control switch connector (A) and then remove the cruise control switch (C) with two screws (B).




5. Installation is the reverse of removal.

Inspection

Measuring Resistance
1. Disconnect the cruise control switch connector from the control switch.




2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).





3. If not within specification, replace switch.

Measuring Voltage
1. Connect the cruise control switch connector to the control switch.




2. Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).





3. If not within specification, replace switch.