Exterior C-Pillar Trim Cover - Replacement
Group: BodyNumber: 94-60-002
Date: OCTOBER, 1994
Model: SCOUPE
Subject:
"C" PILLAR COVER INSTALLATION - REPLACEMENT QUARTER PANEL
The Scoupe quarter panel "C" has been revised to eliminate the exterior trim mounting holes. To install the "C" pillar trim onto a vehicle which was repaired by replacing the quarter panel, use 3 spots of glass sealant or RTV sealant in the mounting clip locations and allow to set for 24 hours.
Installation:
1. Wipe down the "C" pillar with isopropyl alcohol or other wax and grease remover. Wipe dry. Remove the clips from the "C" pillar trim and clean it in the same manner.
2. Apply glass sealant or RTV to the clip locations on the "C" pillar.
3. Push the "C" pillar trim into place. Check the fit along the top and bottom verifying the fit is similar to the other side of the vehicle. Secure the trim in place with tape.
PARTS INTERCHANGEABILITY:
The new replacement part numbers must be modified, as explained. to fit vehicle applications before production effective date February 16, 1993.