Solenoid Test

NOTE
- When disconnecting the vacuum hose, make an identification mark on it so that it can be reconnected to its original position.

1. Disconnect the vacuum hose (black with red stripe) from the solenoid valve.
2. Detach the harness connector.





3. Connect a vacuum pump to the nipple to which the red-striped vacuum hose was connected.





4. Apply vacuum and check when voltage is applied to the purge-control solenoid valve and when the voltage is discontinued.





5. Measure the resistance between the terminals of the solenoid valve.

Solenoid Valve Coil resistance: 36 - 44 ohms at 20° C (68°F)