Throttle Cable/Linkage: Service and Repair

REMOVAL





1. Remove the bushing and inner cable of the accelerator arm side.





2. Loosen the bolts of the accelerator arm bracket and remove.

INSTALLATION
1. When installing the return spring and accelerator arm, apply multi-purpose grease around each moving point of the accelerator arm.
2. Apply sealant to the bolt mounting hole, and tighten the accelerator arm bracket.

Tightening:
Arm bracket bolts torque: 8 - 12 Nm (6 - 7 lb.ft)

3. Securely install the resin bushing of the accelerator cable on the end of the accelerator arm.