Crankshaft: Specifications
DIMENSIONSCrankshaft Rod Bearing Oil Clearance
Standard Value 0.020-0.050 mm (0.0008-0.0020 inch)
Wear Limit 0.100 mm (0.0040 inch)
Crankshaft Main Bearing Oil Clearance
Standard Value 0.020-0.050 mm (0.0008-0.0020 inch)
Wear Limit 0.100 mm (0.0040 inch)
Crankshaft Rod Journal O.D. 44.980-44.995mm (1.7709-1.7715 inch)
Crankshaft Main Journal O.D 56.980-56.995 mm (2.2433-2.2439 inch)
End Play
Standard Value 0.050-0.180 mm (0.0020-0.0071 inch)
Wear Limit 0.250 mm (0.0098 inch)
Journal Out-Of-Round Less than 0.015 mm (0.0006 inch)
Journal Pit Less than 0.015 mm (0.0006 inch)
Taper Of Journal And Pin Less than 0.005 mm (0.0002 inch)
TIGHTENING SPECIFICATIONS
Oil Seal Case Bolts 10-12 Nm (100-120 kg. cm, 7-9 ft. lbs.)
Main Bearing Cap Bolts 65-70 Nm (650-700 kg. cm, 47-51 ft. lbs.)
NOTE:
- Use a sequence of center cap, No.2 cap, No.4 cap, front cap and rear cap.
- Cap bolts should be tightened evenly in 4 to 5 stages before they are tightened to specified torque.