Left Balance Shaft

REMOVAL

NOTE: The left balance shaft is driven by the oil pump sprocket.






1. Remove the plug at the left side of the cylinder block and insert a screwdriver to keep the left counter balance shaft in position.

NOTE: Use a screwdriver with a shaft measuring 8 mm (0.3 inch) in diameter which can be inserted being more than 60 mm (2.36 inch)

2. Remove the oil pump sprocket retaining nut and the oil pump sprocket.

INSTALLATION
Installation is the reverse of removal, tighten oil pump sprocket nut to 50-60 Nm (500-600 kg. cm, 36-43 ft. lbs.)