Fuel Pressure Release: Service and Repair

CAUTION: Safety glasses must be worn when performing this service.

1. Reduce the internal pressure of the fuel pipes and hoses by the following procedures.




- Disconnect the fuel pump harness connector after removing the rear seat cushion.
- Start the engine and after it stalls, turn the ignition switch to the OFF position.
- Disconnect the battery negative (-) terminal
- Connect the fuel pump harness connector

2. The fuel filter is located in the left side of the rear quarter of the engine compartment.
3. Remove the single tie-wrap that secure the fuel pressure line to the fuel return line.




4. Remove the electrical connector from below the master cylinder reservoir.

CAUTION: Before proceeding to next step, place shop rag over fuel filter to capture fuel spray.

5. Move shop rag enough to expose bolt on top of fuel filter, remove bolt and line from filter.