Internal Gear and Transfer Drive Gear Set Assembly
INTERNAL GEAR AND TRANSFER DRIVE GEAR SET ASSEMBLYComponents
Disassembly
1. Remove snap ring from rear end of output flange.
2. Using special tool (09455-21000), pull of ball bearings from output flange.
3. Remove snap ring, and separate internal gear from output flange.
Reassembly
1. Using special tool (09455-21100), press ball bearing and transfer drive gear onto output flange.
CAUTION: Replace output flange and transfer drive gear as a set.
2. Install transfer drive gear in proper direction, noting the groove in side surface.
3. Install the ball bearing.
4. Select the thickest snap ring that can be installed in groove.
Standard value:
Snap ring: 0 - 0.06 mm (0 - 0.236 inch)