Speedometer Gear, A/T: Service and Repair

SPEEDOMETER DRIVEN GEAR ASSEMBLY





Components

Disassembly

- Drive spring pin out, and gear and sleeve can be disassembled.

CAUTION: Do not reuse O-rings and spring pin.

Reassembly





1. Install a new O-ring to the shaft part of the gear. Coat the O-ring with a small amount of automatic transaxle fluid.
2. Insert the gear into the sleeve, and align the pin hole and the groove of the gear's shaft.
3. Tap a new spring pin into the sleeve. When tapping it in, be sure that the slit is not at the gear side.
4. Install a new O-ring into the outer groove of the sleeve. Coat the outer circumference of the O-ring with a small amount of automatic transaxle fluid.