Step 7 - Installation of the ATM Lower Shift Console

^ Set the parking brake, turn the ignition key to the "ON" position and move the shifter lever to "2nd".

^ Remove the black plastic trim shroud from the shift console by using a plastic trim removal tool. Carefully pry up at the front. When the front is loose, carefully slide the trim piece forward to release the horizontal tabs at the rear.

CAUTION:
The rear horizontal tabs will break if the plastic trim is pulled up.

^ Remove the tape backing with the pull tab.

^ Install black plastic trim shroud onto the wood trim, making sure to slide the rear tabs behind the woodgrain piece.

^ Hold the front edge away from the console.

^ Work from the back to front. Press the shroud front locking tabs into position.

^ Press the wood trim into the contour.

^ Apply extra heat to the front third of the wood trim to help it conform to the contour.