Internal Gear and Transfer Drive Gear Set Assembly

INTERNAL GEAR AND TRANSFER DRIVE GEAR SET ASSEMBLY

Components





Disassembly





1. Remove the snap ring from the rear end of the output flange.





2. Using special tools (09457-22000, 09455-33200) remove bearings (2 pieces) and transfer drive gear from the output flange.





3. Using special tools (09457-22000, 09522-31000) remove the drive gear inner bearing.





4. Remove the snap ring, and separated the internal gear from the output flange.

Reassembly





1. Using special tool (09455-33200) press the ball bearing and transfer drive gear onto the output flange.

CAUTION: Replace the output flange and transfer drive gear a set.

2. Install the transfer drive gear in the proper direction noting the groove in the side surface.





3. Install the ball bearing with special tool (09455-33200).





4. Select the thickness snap ring that can be installed in the groove.

Standard value: 0 - 0.09 mm