Speedometer Driven Gear

SPEEDOMETER DRIVEN GEAR ASSEMBLY

Components





Disassembly

Drive out the spring pin so the gear and sleeve can be disassembled.

CAUTION: Do not reuse the O-ring, oil seal and spring pin.

Reassembly





1. Install a new oil seal to the shaft part of the gear, and apply a small amount of ATE onto the oil seal.
2. Insert the gear into the sleeve, and align the pin hole and the groove of the gear's shaft.
3. Tap a new spring pin into the sleeve. When tapping it in, be sure that the slit is not at the gear side.
4. Install a ness O-ring into the outer groove of the sleeve, and then apply a coating of a small amount of ATE to the outer circumference of the O-ring.