Rear Wheel Alignment
REAR WHEEL ALIGNMENTTOE-IN
Standard value: 2 ± 2 mm
NOTE: The assist arm mounting bolt (crossmember side) should be turned an equal amount on both sides when adjusting.
Inside direction of the vehicle: toe-in
Outside direction of the vehicle: toe-out
The scale has gradations of approximately 2.4 mm (14').
CAMBER
Standard value:
-30' ± 30' (For general suspension)
38' 331 30' (For high suspension)
NOTE:
1) The rear suspension assembly must be free of worn, loose or damaged parts prior to measuring rear wheel alignment.
2) Camber is pre-set at the factory and cannot be adjusted.
3) If camber is not within the specifications, replace bent or damaged parts.