Campaign - Keyless Entry Programming

Group
60 - BODY

Number
01-01-002

Date
01-2001

Model
Elantra, 2001

Subject
2001 ELANTRA KEYLESS ENTRY PROGRAMMING SERVICE CAMPAIGN 912

DESCRIPTION:

Some 2001 Elantra vehicles were delivered with only one keyless entry remote transmitter. A second remote has been sent to Elantra owners who only received one transmitter when they took delivery of the vehicle.

This TSB provides the instructions describing how to reprogram the ETACS control module to recognize the second remote.

CODE SAVING TOOL KIT





The 1-45346 Transmitter Programmer Kit is required to reprogram the ETACS control module to recognize remotes. To reprogram the ETACS control module in the 2001 Elantra, the following two items are required.

^ Code Saver (P/N J-45346-TXR1)
^ Code Saver Main Harness (P/N J-45346-TXR0)

PROGRAMMING INSTRUCTIONS FOR 2001 ELANTRA:





1. Verify that the power bar in the interior fuse box is in the "On" position.

2. Remove ignition key

3. Connect the main harness (J-45346-TXR0) and the Code Saver (J-45346-TXR1) together securely.





4. Connect main harness to the white 10-pin multipurpose connector located under the dash.





5. Move Code Saver switch from "Ready" to "Save".

6. Press either button on one remote and hold until remote LED turns off.

7. Repeat previous step with remaining remote.

8. Move Code Saver switch back to "Ready" position.

9. Unplug Code Saver from vehicle's multipurpose connector.

10. Test remotes.

NOTE
The ETACS control module in a vehicle can only be programmed to accept two remote transmitters and the ETACS control module MUST be programmed for both remote transmitters at the same time.





CAMPAIGN CLAIM INFORMATION