Automatic Update Procedure

1. Remove any software cards from the Hi-Scan Pro and insert reprogramming card into the Hi-Scan Pro top slot. (Red 32MB Card)

2. Connect the reprogramming adapter to the Hi-Scan Pro.

3. Connect the red 10 pin connector to the reprogramming adapter.

4. Connect power cable to the Hi-Scan Pro from the cigarette power adapter.

5. Insert the power cable from the reprogramming adapter into the cigarette power adapter.





6. Connect the cigarette power adapter into the vehicle cigarette power socket.

7. Connect the red 10 pin connector to the white reprogramming connector at the lower crash pad next to the Data Link Connector (DLC).

8. Turn the ignition to the ON position.

9. Turn the Hi-Scan Pro ON.





10. Select option "29. XG 300 4-5 SHUDDER & REAR 02 SENSOR" and press ENTER.





11. Select option "01. XG 300 AT 4-5 SHUDDER [AUTO MODE]" and press ENTER.





12. Enter "1229" as the password for automatic update and press ENTER.





13. The Hi-Scan Pro will establish communication.





14. The Hi-Scan Pro detects the current ECM and TCM IDs, then displays them for about 1 second.





Example





15. The Hi-Scan Pro will download the new ECM and TCM programs at the same time.

NOTE:
If the Hi-Scan Pro does not download the program after trying several times, use the Manual Update Procedure following this section.

WARNING:
Do not interrupt the reprogramming at any time. The ECM and TCM may be rendered inoperative if the program does not download completely.





16. When the "REPROGRAMMING COMPLETED! message is displayed, the ECM and TCM reprogramming process is complete. Press ENTER and turn off the Hi-Scan Pro and turn the ignition key to the off position for 20 seconds.





NOTE:
Confirm the Hi-Scan Pro displays the new ECM and TCM IDs shown.

17. Start the engine to check for proper operation.