Glass and Regulator

1. Remove the door trim, door trim seal, speaker.




2. Carefully move the glass by the power window switch until the 2 mounting bolts appear, then remove them.

TORQUE :8 - 12 Nm (80 - 120 kgcm, 6 - 9 lb-ft)




3. Separate the glass from the glass run and carefully pull the glass out through the window slot.

CAUTION: Be careful not to drop the glass and scratch the glass surface.




4. Disconnect the power window motor connector.
5. Loosen the regulator mounting nuts(4EA) and power window motor mounting nuts(3EA), then remove the regulator assembly.

TORQUE : 4 - 6 Nm (40 - 60 kg.cm, 3 4 lb-ft)




6. After loosening the front channel mounting nuts(2EA), remove the front channel.
7. Installation is the reverse of removal.