Ignition Switch: Service and Repair

REMOVAL AND INSTALLATION




1. Disconnect the negative(-) battery terminal.




2. Remove the 2 bolts and disconnect the airbag connector and the horn connector, then remove the airbag module.

NOTE: Remove the horn pad only for vehicle without airbag.




3. Remove the steering wheel lock nut.




4. Remove the steering wheel with special tool (09561-11002)

NOTE: Do not hammer on the steering wheel to remove it. Doing so may damage the collapsible mechanism.




5. Remove the steering column shroud after removing 3 screws.




6. Remove the screws holding the multi-function switch then disconnect the wire connector.
Remove the multi-function switch assembly.




7. Remove the steering column mounting bolts.
8. Remove the key lock assembly from the steering column shaft.
9. Installation is the reverse of removal.