Rear Wiper Motor

REMOVAL




1. Remove the tailgate trim panel.




2. Remove the rear wiper arm after removing a nut

Tightening torque 7-11 Nm (70 - 110 kgcm, 5.1-8.0 lb-ft)




3. Remove a hexagonal nut after removing a pivot cover.

NOTE: When installing cap & pad, the arrow mark should be indicated upward.

Tightening torque: 10 - 14 Nm (100 - 140 kg.cm, 7.3 - 10.2 lb-ft)




4. Remove the rear wiper motor after removing 2 bolts and disconnect the wire connector.

Tightening torque: 4-7 Nm (40 - 70 kg.cm, 2.9 - 5.1 lb-ft)

5. Installation is the reverse of removal.

INSTALLATION




1. Install the rear wiper arm and blade to the specified position.




2. Set the rear washer nozzle on the specified spray Position.