P0057

DTC P0057 O2 Sensor Heater Circuit Low Input (Bank 2, Sensor 2)

DESCRIPTION
In order to control emissions of the CO, HC and NOx components of the exhaust gas, heated oxygen sensor (HO2S), mounted on the front side and rear side of catalytic converter, detects the oxygen content in the exhaust gas. The front HO2S signal is used to control air/fuel ratio (closed loop fuel control) and the rear HO2S signal is used to monitor front HO2S and catalyst for proper operation.The HO2S requires a minimum temperature to operate properly and provide a closed loop fuel control system. So HO2S contains the heater element to reduce its warming-up time and ensure its performance during all driving conditions, which can operate closed loop fuel control or catalyst monitoring immediately upon engine start-up.The ECM controls this heater element by duty cycle The main relay supplies voltage to the heater and the ECM provides a ground circuit for activating the heater.

DTC Detecting Condition:

Specifications:

Schematic Diagram:

Signal Waveform:

Step 1:

Step 2 - 4:

INSPECTION PROCEDURE