Fuel Pump: Service and Repair

FUEL PUMP (FP)

INSPECTION
1. Turn the ignition switch OFF.
2. Using the HI-scan(Pro)'s actuator test mode for fuel pump, check that pump operation.

NOTE: The fuel pump is an in-tank type and its operation is hard to hear without removing the fuel tank cap.




3. Pinch the hose to check that fuel pressure is felt.

FUEL FILTER

REPLACEMENT

FUEL FILTER
1. Reduce the internal pressure of the fuel lines and hoses by completing the following operations.
- After removing the rear seat cushion, disconnect the fuel pump harness.
- Start the engine. Allow it to stop by itself, then turn the ignition switch OFF.
- Disconnect the battery negative (-) terminal.




- Connect the fuel pump harness connector.
2. Remove the eye bolts while holding the fuel filter nuts securely.

CAUTION: Cover the fuel filter with a shop towel to avoid residual gasoline from splashing.

3. Remove the fuel filter mounting bolts, then remove the fuel filter from the fuel filter clamp.
4. After replacing the fuel filter, check for fuel leaks.

FUEL SENDER
1. Remove the fuel tank cap to lower the fuel tank's internal pressure.




2. Remove the fuel sender mounting screws, then remove the fuel sender from the fuel tank.