Side Impact Sensor
SIDE IMPACT SENSOR REPLACEMENTREMOVAL
CAUTION:
- Removal of the airbag must be performed according to the precautions"procedures described previously.
- Before disconnecting the side impact sensor 2P connector(s), disconnect the side airbag 2P connector(s).
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Disconnect the negative battery cable, and wait at least three minutes before beginning work.
2. Remove the seat assembly.
3. Remove the front door sill trim.
4. Remove the center pillar trim.
5. Remove the lower anchor bolt.
6. Remove the belt pretensioner.
7. Remove the two bolts then remove the side impact sensor (A).
8. Disconnect the SRS harness 2P connector from the side impact sensor.
INSTALLATION
CAUTION:
- Be sure to install the harness wires so that they are not pinched or interfere with other parts.
- Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1. Install the new side impact sensor with the two bolts then connect the SRS harness 2P connector to the side impact sensor.
2. Reinstall belt pretensioner.
3. Reconnect the negative battery cable.
4. After installing the side impact sensor, confirm proper system operation: Turn the ignition switch ON: the SRS indicator light should blink for about six seconds and then go off.