Seat Position Sensor: Service and Repair

SEAT TRACK POSITION SENSOR REPLACEMENT

REMOVAL

1. Disconnect the battery negative cable and wait at least three minutes before beginning work.
2. Remove the seat assembly.




3. Disconnect the seat track position sensor 2P connector (A).




4. Remove the seat track position sensor (A).

INSTALLATION

CAUTION: Be sure to install the harness wires so that they are not pinched or interfere with other parts.

1. Install the new seat track position sensor.
2. Connect the seat track position sensor 2P connector.
3. Install the seat assembly.
4. Reconnect the battery negative cable.
5. After installing the seat track position sensor, confirm proper system operation: Turn the ignition switch ON; the SRS indicator light should blink for about six seconds and then go off.
6. Recline and slide the front seat forward fully, make sure the harness wires are not pinched or interfering with other parts.