Rear Door: Service and Repair
Rear DoorRear Door:
REMOVAL AND INSTALLATION
1. Remove the door window regulator handle and then remove clip using a piece of cloth (Manual type only).
2. Remove the rear door inside handle housing.
3. Remove the 3 mounting screws from the rear door trim panel.
4. Insert a trim panel remover between the trim fasteners and the door trim panel to pry off. Disconnect the connector.
5. Remove the door pull handle mounting bracket and inside door handle.
6. Remove the door trim seal.
7. Lower the door glass and remove the door glass run and delta lower channel.
Tightening torque
Rear door glass mounting bolts: 8-12 Nm (80-120 kg.cm, 5.8-8.7 lb.ft)
Delta lower channel mounting bolts: 8-12 Nm (80-120 kg.cm, 5.8-8.7 lb.ft)
8. Remove the carrier plate mounting bolts from the door regulator channel and remove the door glass.
9. Remove the door regulator channel mounting bolts and then remove the door regulator assembly.
Tightening torque
Door regulator channel mounting bolts: 4-6 Nm (40-60 kg.cm, 2.9-4.4 lb.ft)
10. Loosen the door lock actuator mounting bolts and remove the latch assembly.
11. Remove the outside door handle mounting bolts.
12. Remove the waistline molding.
13. Installation is the reverse of removal.
When installing the door trim seal, butyl tape should not be placed over door trim fastener mounting area.