Operation CHARM: Car repair manuals for everyone.

Fuel Filter: Service and Repair

FUEL PUMP (FP)

OPERATION CHECK
1. Turn the ignition switch to the OFF position.
2. Apply battery voltage to the fuel pump drive connector to check that the pump operates.

NOTE: The fuel pump is in-tank type and its operating sound is hard to hear without removing the fuel tank cap.




3. Pinch the hose to check that fuel pressure is felt.

FUEL FILTER

REPLACEMENT
1. Reduce the internal pressure of the fuel lines and hoses and perform the following operations.
- Disconnect the fuel pump harness connector in the trunk room.
- Start the engine and, after it stops, turn the ignition switch to OFF.
- Disconnect the battery negative (-) terminal.
- Connect the fuel pump harness connector.

2. Remove the two fitting nuts while holding the fuel filter nuts securely.




3. Remove the fuel filter mounting bolts, and then remove the fuel filter from the fuel filter clamp.

Tightening torque
Fuel filter fining nut: 25 - 35 Nm (25 - 35 kg.cm, 18 - 25 lb.ft)