Coolant Temperature Sensor/Switch (For Computer): Service and Repair
COOLANT TEMPERATURE SENSORREMOVAL
1. Drain the coolant to a level below the bottom of the sensor.
2. Disconnect the ground cable from the battery and then remove the sensor connector.
3. Remove the coolant sensor.
INSTALLATION
1. Tighten the coolant temperature sensor to the specified torque after applying the sealant to the screw area.
Recommended sealant
Threebond No. 1324N or LOCTITE 262
Tightening torque
The coolant temperature sensor: 20 - 40 Nm (200 - 400 kg-cm, 14 - 29 ft. lbs.)
2. Connect the sensor to the harness.
3. Connect the ground cable to the battery.
4. Refill the engine coolant.