Passenger Side Replacement

REMOVAL

NOTE:
1. Never attempt to disassemble or repair the airbag module.
2. Do not drop the airbag module or allow contact with water, grease or oil. Replace it if a dent, crack, deformation or rust is detected.
3. The airbag module should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top of it.
4. Do not expose the airbag module to temperatures over 93° C (200° F)
5. An undeployed airbag module should only be disposed in accordance with the proper procedures.
6. Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester If the circuit resistance is measured with a tester, accidental airbag deployment could result in serious personal injury.
7. Whenever the PAB is deployed it should be replaced with a new one, assembled with a new extension wire. The squib is melted when the PAB is deployed making the old extension wire useless.




1. Disconnect the battery negative (-) terminal cable.

CAUTION: Wait at least 30 seconds.

2. Remove the glove box.
3. Disconnect the PAB module connector.




4. Remove the crash pad assembly and then undo the PAB module.




5. The skin of passenger Airbag module is integrated with the crash pad. Replace the crash pad if PAB is deployed.