Reassembly

REASSEMBLY




1. After reassembling the compressor assembly by the reverse of the disassembly procedure given, check the clutch air gap between the clutch hub and the pulley mating surface with a feeler gauge. The air gap should be as follows.

Air gap: 0.35 - 0.65 mm (0.014 - 0.026 inch)

NOTE: When reassembling the compressor assembly clean the pulley bearing surface and coil press diameter of the front head to remove any dirt or corrosion.

2. If the clutch air gap is not within the dimensions specified above, adjust the various thickness shims until the air gap is within the specified limits.