Rear Wheel Alignment

REAR WHEEL ALIGNMENT

TOE-IN

Standard value: 2 ± 2 mm

NOTE:
1. The assist arm mounting cam bolt (crossmember side) should be turned an equal amount on both sides when adjusting.
Inside direction of the vehicle: toe-in
Outside direction of the vehicle: toe-out





2. The scale has gradations of approximately 2.4 mm (14').

CAMBER
Standard value: -30 ± 30

NOTE:
1. The rear suspension assembly must be free of worn, loose or damaged parts prior to measuring rear wheel alignment.
2. Camber is pre-set at the factory and cannot be adjusted.
3. If camber is not within the specifications, replace bent or damaged parts.

TIRE WEAR





1. Measure the tread depth of the tires.
Tread depth of tire [Limit]: 1.6 mm (0.06 inch)
2. If the remaining tread depth is less than the limit, replace the tire.

NOTE: When the tread depth of the tires is reduced to 1.6 mm (0.06 inch) or less, the wear indicators will appear.