Brakes - Rear Brake Squeak On Application

Group: BRAKE SYSTEM

Number: 08-BR-002

Date: DECEMBER, 2008

Model: VERACRUZ, AZERA, TIBURON, SANTA FE

Subject: REAR DISC BRAKE PAD REPLACEMENT

SERVICE PROCEDURE

DESCRIPTION:
If a vehicle exhibits a squeaking noise originating from the rear disc brakes when applying the brakes, follow the repair procedure outlined below to correct this condition.

AFFECTED VEHICLES:

^ Models: Veracruz (EN), Azera (TG), Tiburon (GK), Santa Fe (CM) and Santa Fe (SM) with rear disc brakes.

^ Affected vehicle production date range: From start of production to most current (refer to the parts application table)





PARTS INFORMATION:

SERVICE PROCEDURE:
Confirm the noise is originating from the rear disc brakes. Upon confirmation, replace the rear brake pads with the applicable part number specified in this bulletin.

Replace the rear disc brake pads by following the procedure outlined in the applicable shop manual and perform the following steps:





1. Before replacing the rear brake pads, remove any corrosion from the pad retainer contact surface of the caliper carrier by using a wire brush.

2. Apply recommended grease on the pad retainer contact surface of the caliper that was brushed in step 1.





RECOMMENDED GREASE FOR CALIPER:

3. Install two new brake pad retainers received with the new brake pads on to the caliper carrier and apply the recommended grease on the pad retainers.

CAUTION: Do not apply grease onto the friction surfaces of the brake pads.





RECOMMENDED GREASE FOR RETAINERS:

4. Install two new brake pads and complete assembly of all components in the reverse order of removal.

NOTE: Make sure to install the pad with wear indicator on the inside position

5. Repeat the above procedure for other side.

Normal warranty procedures applies.