Glass and Regulator
REMOVAL AND INSTALLATION1. Remove the front door inside handle housing.
2. Remove the screws holding the door trim panel.
3. Insert a trim panel remover between the trim fasteners and the door trim panel to pry off. Disconnect the wire connectors from the front door.
4. Remove the door grip handle mounting bracket and door inside handle.
5. Remove the amp speaker and door trim seal.
6. Remove the door glass stopper catch.
NOTE: Does not remove the door glass stopper if you don't want to change the door glass.
7. Loosen the carrier plate mounting bolts in the regulator channel and remove the door glass.
8. Remove the power window regulator after removing the mounting bolts.
9. Remove the door glass channel mounting bolt and nut.
10. Remove the front door belt outside weatherstrip.
11. Remove the front door outside mirror, the mounting bolts.
12. Detach the handle rod, lock rod and then remove the door outside handle.
13. Remove the door latch and door lock actuator.
14. Remove the door wiring harness.
Remove the door checker and door mounting bolts and detach the door assembly.
15. Installation is the reverse of removal.
CAUTION: When installing the door trim seal, butyl tape should not be placed over the door trim fastener mounting area.