Rear Wheel Alignment
REAR WHEEL ALIGNMENTTOE-IN
Standard value: 2 ±2 mm
NOTE:
1. The assist arm mounting cam bolt (crossmember side) should be turned an equal amount on both sides when adjusting.
Inside direction of the vehicle: toe-in Outside direction of the vehicle: toe-out
2. The assist arm mounting cam bolt should be adjusted to a maximum of 90° left or right from the center position.
3. The scale has gradations of approximately 2.4 mm (14').
CAMBER
Standard value: -30' ± 30
NOTE:
1. The rear suspension assembly must be free of worn, loose or damaged parts prior to measuring rear wheel alignment.
2. Camber is pre-set at the factory and cannot be adjusted.
3. If camber is not within the specifications, replace bent or damaged parts.