B1512
DTC B1512The Seat Belt Buckle Switch (BS) circuit consists of the SRSCM and two BS. The SRSCM sets above DTC(s) if it detects short or short to ground on the BS circuit. This system decides whether the driver or passenger seat belt is buckled or not.
DTC Detecting Condition:
Schematic Diagram:
Specification:
TERMINAL & CONNECTOR INSPECTION
1. Visually inspect all connectors related to the affected circuit for damage and secure connection.
2. Inspect terminals for damage and corrosion.
CAUTION: Avoid damaging connectors during the inspection process.
3. Are any problems found?
NO - Go to next step (INSPECTION PROCEDURE).
YES - After repairing the trouble part, check whether DTC occurs or not.
INSPECTION PROCEDURE
1. PREPARATION
1. Turn the ignition switch to LOCK.
2. Disconnect the battery negative cable from the battery and wait for at least 3 minutes.
3. Remove the DAB module and disconnect the DAB connector.
4. Disconnect the connectors of the PAB, SAB, CAB, BPT, FIS and SIS.
5. Disconnect the SRSCM connector.
2. CHECK SHORT OR SHORT TO GROUND
A. Disconnect the BS connector.
B. Measure resistance between the terminal 3 of BS harness connector and chassis ground.
C. Measure resistance between the terminal 3 and 4 of BS harness connector.
specification (Resistance) : Infinite
D. Is the measured resistance within specification?
YES - Go to next step.
NO - Repair the short or short to ground circuit on wiring harness between the BS and the SRSCM.
3. CHECK THE SEAT BELT BUCKLE SWITCH (BS)
A. Measure current between the terminal 3 of BS and 32(31) of SRSCM harness connector (B).
specification (current) : 12 - 18 mA (Buckled status), 4 - 7 mA (Unbuckled status)
B. Is the wiring harness normal?
YES - Go to next step.
NO - Replace the BS.
4. CLEAR THE DTC AND CHECK THE VEHICLE AGAIN
1. Install the DAB module and connect the DAB connector.
2. Connect the connector of the PAB, SAB, CAB, BPT, FIS and SIS.
3. Connect the SRSCM connector.
4. Connect the battery negative cable to the battery.
5. Connect a Hi-Scan (Pro) to the data link connector.
6. Turn the ignition switch to ON.
7. Clear the DTC stored in the SRSCM memory with the Hi-Scan (Pro)
8. Turn the ignition switch to LOCK and wait for at least 30 seconds.
9. Turn the ignition switch to ON and wait for at least 30 seconds.
10. Check the vehicle again with the Hi-Scan(Pro).
Does the above DTC(s) go off?
YES - Problem is intermittent or was repaired and SRSCM memory was not cleared.
NO - Replace the SRSCM with a new one and then check the vehicle again. At this time, if the vehicle normally operates with a new one, the fault may be the SRSCM. Replace the SRSCM.