Hydraulic Pressure Test
HYDRAULIC PRESSURE TEST1. Warm up the engine until the automatic transaxle fluid temperature is 80-100°C (176-212°F).
2. Jack up the vehicle so that the wheels are free to turn.
3. Connect the engine tachometer.
4. Connect the oil pressure gauge (09452-21500) and the oil pressure gauge adapter (09452-21002, 09452-21001) to each pressure discharge port. But use the gauge (30kg/cm2) when measuring the reverse pressure, front clutch pressure and low & reverse brake pressure.
5. If a value is outside the standard range, correct the problem while referring to the hydraulic pressure test diagnosis table.
STANDARD HYDRAULIC PRESSURE TEST:
NOTE:
^ "-" is 0.2 (0.3)kg/cm2 or less and "()" is the reverse.
^ SW-ON: Turn the overdrive control switch ON.
^ SW-OFF: Turn the overdrive control switch OFF.
^ The hydraulic pressure may be more than standard value at the ambient temperature.