P0708
DTC P0708 TRANSAXLE RANGE SWITCH - HIGH INPUTCOMPONENT LOCATION
Refer to DTC P0707. P0707
GENERAL DESCRIPTION
Refer to DTC P0707. P0707
DTC DESCRIPTION
The PCM/TCM sets this code when the Transaxle Range Switch outputs multiple signals for more than 30 seconds.
DTC DETECTING CONDITION
DTC DETECTING CONDITION:
MONITOR SCAN TOOL DATA
Refer to DTC P0707. P0707
TERMINAL & CONNECTOR INSPECTION
Refer to DTC P0707. P0707
POWER CIRCUIT INSPECTION
1. Disconnect "TRANSAXLE RANGE SWITCH" connector.
2. Ignition "ON" & Engine "OFF".
3. Measure voltage between each terminal (C09) of the sensor harness connector and chassis ground.
Specification:
Specification:
4. Is voltage within specifications?
YES - Go to "Signal Circuit Inspection" procedure.
NO - Check for Short in harness. Repair as necessary and Go to "Verification of Vehicle Repair" procedure.
SIGNAL CIRCUIT INSPECTION
1. Ignition "OFF".
2. Disconnect "TRANSAXLE RANGE SWITCH" and "TCM (PCM)" connector.
3. Measure resistance between each terminals of the sensor harness to check for Short.
Specification: Infinite
Specification:
4. Is resistance within specifications?
YES - Go to "Component Inspection" procedure.
NO - Check for Short in harness. Repair as necessary and Go to "Verification of Vehicle Repair" procedure.
COMPONENT INSPECTION
Refer to DTC P0707. P0707
VERIFICATION OF VEHICLE REPAIR
Refer to DTC P0707. P0707