P0713
DTC P0713 FLUID (OIL) TEMPERATURE SENSOR CIRCUIT - HIGHCOMPONENT LOCATION
Refer to DTC P0712. P0712
GENERAL DESCRIPTION
Refer to DTC P0712. P0712
DTC DESCRIPTION
This DTC code is set when the ATF temperature output voltage is higher than a value generated by thermistor resistance, in a normal operating range, for an extended period of time. The TCM regards the ATF temperature as fixed at a value of 80°C (176°F).
DTC DETECTING CONDITION
DTC DETECTING CONDITION:
SPECIFICATION
Refer to DTC P0712. P0712
MONITOR SCAN TOOL DATA
Refer to DTC P0712. P0712
TERMINAL & CONNECTOR INSPECTION
Refer to DTC P0712. P0712
SIGNAL CIRCUIT INSPECTION
1. Ignition "OFF".
2. Disconnect the "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.
3. Measure the voltage between terminal "1" of the "TRANSAXLE FLUID TEMPERATURE SENSOR" harness connector and chassis ground.
Specification: Approximately 5 V
Specification:
4. Is voltage within specifications?
YES - Go to "Ground circuit inspection" procedure.
NO - Check for short to ground in harness. Repair as necessary and Go to "Verification of Vehicle Repair" procedure.
GROUND CIRCUIT INSPECTION
1. Ignition "OFF".
2. Disconnect the "TRANSAXLE FLUID TEMPERATURE SENSOR" connector.
3. Measure the resistance between terminal "2" of the "TRANSAXLE FLUID TEMPERATURE SENSOR" harness connector and chassis ground.
Specification: Approximately 0 Ohms
Specification:
4. Is resistance within specifications?
YES - Go to "Component Inspection" procedure.
NO - Check for open in harness. Repair as necessary and Go to "Verification of Vehicle Repair" procedure.
COMPONENT INSPECTION
Refer to DTC P0712. P0712
VERIFICATION OF VEHICLE REPAIR
Refer to DTC P0712. P0712