Operation CHARM: Car repair manuals for everyone.

Engine: Specifications

Part 1:




Part 2:




Part 3:




Part 4:





SPECIFICATIONS





SERVICE STANDARDS

Part 1:




Part 2:




Part 3:





TIGHTENING TORQUE

Main bearing cap bolt





Install and uniformly tighten the 10 bearing cap bolts (A), in several passes, in the sequence shown.
Retighten the bearing cap bolts by 60° - 65° in the numerical order shown.
Tightening torque
Main bearing cap bolt 30 Nm (300 kgf-cm, 22 ft. lbs.) + 60° - 65°

Cylinder Head bolts





Using 8 mm and 10 mm hexagon wrench, install and tighten the 10 cylinder head bolts and plate washers, in several passes, in the sequence shown.

Water pump sequence





Install the water pump (B) and a new gasket with the 3 bolts.
Install the alternator brace (A) with the 2 bolts (C).
Install the 4 bolts and pump pulley.

Oil pump sequence





Install the oil pump on the cylinder block.
Place a new front case gasket on the cylinder block. Apply engine oil to the lip of the oil pump seal. Then, install the oil pump onto the crankshaft. When the pump is in place, clean any excess grease off the crankshaft and check that the oil seal lip is not distorted.