Shift Linkage: Adjustments
Procedure For Adjusting The Shift Lock And Key Lock Cable1. Check that each lock cam is located in position as shown.
2. Install the shift lock cable and key lock cable in position. In this case, the key lock cable must be fixed to the key cylinder and the shift lock cable must be fixed to the brake pedal in position.
3. Temporarily install each cable to the A/T lever assembly as shown. Securely insert the cable into the fixing pin of each cam.
4. Keep a gap of 2-4 mm between the key lock cam and the P-lock cam to eliminate cable slack by pulling the shift lock cable slightly in the direction of "E."
CAUTION: If the gap is not maintained between 2 and 4 mm, the brake pedal will have to be depressed more than required when operating the push button of the shift lever.
5. After checking that a portion of the cable end touches cable fixing pin of the P-lock cam, fix the shift lock cable to the A/T lever with the nut and fix the shift lock cable end with the washer and snap pin.
6. Slightly push the key lock cam in the direction of "Q".
7. Performing the work of 6, slightly pull the key lock cable in the direction of "G" to stretch the cable tight and then fix it with a nut.
8. Be sure to check whether the key lock cable is inserted into the fixing pin of the key lock cam, and then fix it with the washer and snap pin. At this time, check if the P-lock cam is fixed to the shift lock cable as illustrated.
