Rear Wiper Motor

REMOVAL




1. Remove the tailgate trim panel (A).




2. Remove the rear wiper arm after removing a nut (A).

Tightening torque
14-17 Nm (140-170 kg-cm, 10.3-12.5 lb-ft)




3. Remove a hexagonal nut (B) after removing a pivot cover (A).

NOTE: When installing cap & pad (C), the arrow mark should be indicated upward.

Tightening torque
10-13 Nm (100-130 kg-cm, 7.3-9.5 lb-ft)




4. Remove the rear wiper motor after removing 3 bolts (A) and disconnect the wire connector (B).

Tightening torque
4-7 Nm (40-70 kg-cm, 2.9-5.1 lb-ft)

5. Installation is the reverse of removal.

INSTALLATION




1. Install the rear wiper arm and blade to the specified position.




2. Set the rear washer nozzle on the specified spray position.