Fuel Pump: Service and Repair

FUEL PUMP (FP)

REMOVAL
1. Preparation




1. Open the Service Cover (A) with unscrewing the bolts (B).




2. Disconnect the Fuel Pump Connector (A).
3. Start the engine and wait until fuel in fuel line is exhausted.
4. After the engine stalls, turn the ignition switch to OFF position.




2. Disconnect the Fuel Feed Line (A), Recirculation Line (B) and Fuel Tank Pressure Sensor connector (C).
3. Unfasten the Fuel Pump Locking Ring (D) with the Special Service Tool (Refer to "SPECIAL SERVICE TOOL").

CAUTION: Be careful NOT TO damage the surface of the fuel rank.





4. Remove the Fuel Pump assembly from the Fuel Tank.

INSTALLATION
Install the Fuel Pump according to the reverse order of REMOVAL procedure.

NOTE: Replace the Fuel Pump Locking Ring and Fuel Pump Plate Packing with a new one when installing the fuel pump again.