A/T - Can't Shift Into/Out Of 'PARK'
Group: AUTOMATIC TRANSAXLENumber: 06-40-008-1
Date: OCTOBER, 2006
Model:
2006-SONATA & AZERA,
2007-SANTA FE, ELANTRA & ENTOURAGE
Subject:
AUTOMATIC TRANSAXLE SHIFT LEVER WILL NOT SHIFT OUT OF PARK
This TSB updates TSB 06-40-008 to include 2007 model vehicles.
DESCRIPTION:
If the shift lever of a 2006 Sonata, Azera or 2007 Santa Fe, Elantra or Entourage vehicle does not shift into or out of Park, please follow the repair procedure:
REPAIR PROCEDURE:
1. Attach a Hi-Scan Pro or GDS and select:
^ Vehicle
^ "Automatic Transaxle",
^ "Current Data"
^ Brake Switch"
2. Confirm the "Brake Switch" reads "ON" when the brake pedal is depressed. If not, check the brake switch clearance according to the related shop manual. If the clearance is within specification, install a known-good brake switch:
^ 2006 or 2007 Sonata, page BR-12
^ 2006 or 2007 Azera, page BR-12
^ 2007 Santa Fe, page BR-22
^ 2007 Entourage, page BR-11
^ 2007 Elantra, page BR-13
^ Check fuses and related wiring as shown in the related E/M, page 5D452-2.
2006 - SONATA
^ Refer to the 2006 or 2007 Sonata Shop Manual, page BD-52 and remove the center panel.
^ Disconnect the M01 connector to the ATM key lock control module. Go to "Test Procedure".
2006 - AZERA:
^ Refer to the 2006 or 2007 Azera Shop Manual, page BD-62 and remove the glove box.
^ Remove the two nuts and disconnect the M76 connector to the ATM key lock control module. Go to "Test Procedure".
2007 - ENTOURAGE:
^ Refer to the 2007 Entourage Shop Manual, page BD-61 and remove the floor console cover.
^ Disconnect the M01 connector to the ATM key lock control module. Go to "Test Procedure".
2007 - SANTA FE:
^ Refer to the 2007 Santa Fe Shop Manual, page BD-63 and remove the center fascia panel.
^ Disconnect the M02 connector to the ATM key lock control module. Go to "Test Procedure". (Refer to the 2007 Santa Fe ETM, page CL- 11, photo 61 for clarity).
2007 - ELANTRA
^ Refer to the 2007 Elantra Shop Manual, page BD-51 and remove the lower panel.
^ Disconnect the M12 connector to the ATM key lock control module. Go to "Test Procedure". (Refer to the 2007 Elantra ETM, page CL-7, photo 38 for clarity).
TEST PROCEDURE:
3. Turn the ignition switch to the "ON" position. Check voltage at the pins according to table. If the voltages are correct, replace the ATM key lock control module.
PARTS INFORMATION
WARRANTY INFORMATION