Driver's Side
REMOVALDAB REMOVAL
1. Disconnect the battery negative cable and wait at least three minutes before beginning work.
2. After removing the cover (A), loosen the two Torx bolt (B).
NOTE: Use the magnetic tool, because the bolts(B) are not separated completely
3. Disconnect the connectors(A) after lifting up the pin(D) and the horn connector(B). Remove the driver's airbag(C) from the steering wheel.
CAUTION: The removed airbag module should be stored in a clean and dry place with the pad cover face up.
CLOCK SPRING REMOVAL
1. Disconnect the negative battery cable, and wait at least 3 minutes before beginning work.
2. Remove the DAB.
3. Remove the steering wheel.
4. Remove the steering column shroud.(Refer to ST-steering column and shaft)
5. Remove clock spring connector(A), then remove clock spring(B).
6. Verify front wheels are pointed straight ahead.
7. Turn clockspring clockwise until it stops. (softly, do not force)
Turn it counter clockwise 3 turns until front wheel is pointed forward.
8. Install on to steering column.
9. Installation is the reverse of removal.
NOTE: After installing the clock spring, confirm proper system operation; Turn the ignition switch ON: the SRS indicator light should turn on for about 6 seconds and then go off