Installation

REAR UPPER ARM

INSTALLATION
1. Install the upper arm to the cross member (D) with two mounting bolts (B).
Tightening torque 100 - 120 Nm (10 - 12 kgf-cm, 72.3 - 86.8 ft. lbs.)





2. Install the upper arm ball joint self-locking nut (A) to the rear axle assembly (C) with a specified torque, and then install the split pin.
Tightening torque 80 - 90 Nm (8 - 9 kgf-cm, 57.8 - 65.1 ft. lbs.)
3. Install the cross member (A).
Tightening torque 140 - 160 Nm (14-16 kgf-cm, 101.2 - 115.7 ft. lbs.)





4. Install the spring, the lower seat, and the upper pad.
5. Install the lower arm bolt (A) to the axle assembly (B), while supporting with a jack.





6. Install the trailing arm (A) and the shock absorber (B) to the rear axle assembly (C).
Tightening torque 140 - 160 Nm (14 - 16 kgf-cm, 101.2 - 115.7 ft. lbs.)





7. Install the brake hose (A), the parking brake cable (B), and the wheel speed sensor (C).





8. Install the muffler (A).





9. Install the wheel, and the We to the rear hub.
Tightening torque: 90 - 110 Nm (11 kgf-cm, 65.1 - 79.5 ft. lbs.)

CAUTION: Be careful not to damage the hub bolts when installing the rear wheel and tire.